Maintenance; Lubrication; Brush Replacement; General Maintenance - RIDGID R3002 Manuel D'utilisation

MAINTENANCE

WARNING:
When servicing use only identical RIDGID
replacement parts. Use of any other parts may
create a hazard or cause product damage.
WARNING:
Always wear eye protection marked to comply with
ANSI Z87.1. Failure to do so could result in objects
being thrown into your eyes resulting in possible
serious injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
Electric tools used on fiberglass material, wallboard, spack-
ling compounds, or plaster are subject to accelerated wear
and possible premature failure because the fiberglass chips
and grindings are highly abrasive to bearings, brushes,
commutators, etc. Consequently, we do not recommend
using this product for extended work on these types
of materials. However, if you do work with any of these
materials, it is extremely important to clean the product
using compressed air.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 12 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.

LUbRICATION

All of the bearings in this product are lubricated with a suf-
ficient amount of high grade lubricant for the life of the unit
®
under normal operating conditions. Therefore, no further
lubrication is required.

bRUSH REPLACEMENT

See Figure 9, page 13.
The reciprocating saw is equipped with externally acces-
sible brushes.
To replace:
 Unplug the saw.
 Remove brush caps (2) using a flat blade screwdriver.
NOTE: The bottom brush cap is located underneath a
cover. To remove the cover, remove the torx screw located
on the left side of the cover.
 Remove brush assemblies (2).
 Check for wear. Replace both brush assemblies when
either has less than 1/4 in. length of carbon remaining.
NOTE: Do not replace one side without replacing the
other.
 Reassemble using new brush assemblies. Make sure
curvature of brush matches curvature of motor and that
brush moves freely in brush tube.
 Reassemble by reversing the steps listed above.
 Tighten all brush caps securely. Do not over tighten.
10 - English