Publicité
programs by pressing the "FUNCTION" button. Then press the "Start/Stop"
button (if you do not press the button within 30 seconds, the blender will go
into standby mode). After that the selected program will start. When the
process is finished, press the "ON/OFF" button and unplug the blender.
NOTE. The maximum continuous operation time is 5 cycles. In case of longer
use, engine will be automaticly blocked. To resume work, you must disconnect
the device from the power supply, remove the bowl and wait for no longer then
10 minutes. After this time, the device will be ready for use again.
You can also turn on the blender in delayed start mode. To do this in standby
mode you must first set the desired time before the program starts. To do this,
first press the "PRESET TIME" button. Then use the "TIME+" and "TIME-" buttons
to set the time required before the device starts. Each press of the Increase
Time and Decrease Time button changes the time until the blender starts by
10 minutes. Then select the desired program with the "Program Selection"
button and then press the "Start/Stop" button. The blender will start itself after
a set period of time, work the selected program, and then go into standby
mode. NOTE. If you set the wrong time before the blender starts, you can
cancel the setting with the "START/STOP" button.
The manual mode allows you to set the duration of operation and rotation
speed of the blade by yourself. To do this, press the "MANUAL" button in
standby mode and then use the "SPEED+" and "SPEED-" buttons to set the
desired speed. Then use buttons "TIME+" and "TIME-" to set the required
operating time of the device in minutes and seconds. Then press the
"START/STOP" button.
The self-cleaning mode helps to clean the blade from stuck pieces of food. To
do this, you need to remove food from the blender, pour 500ml of warm water
with a little dishwashing detergent into the blender and press the "CLEANING"
aeno.com/documents
15
Publicité
