Publicité
BEFORE THE FIRST USE
·
Make sure all packaging materials and promotional stickers have been removed before using the
appliance for the first time.
·
Before using the ice cube maker for the first time: wait 2 hours after putting the appliance in place and
leave the lid open for at least 2 hours. This way the refrigerant can settle.
·
Place the ice cube maker on a flat and stable surface and make sure that the ventilation openings are
not blocked.
·
Clean the appliance before using it for the first time. See: "cleaning and maintenance".
USE
1.
Place the ice cube maker on a flat and stable surface and make sure that the ventilation openings are
not blocked. Make sure the drainage hole on the bottom of the unit is closed.
2.
Open the lid and take out the ice basket so you can pour water into the water tank. It is
recommended to use spring water or mineral water. Do not use hot water, the recommended water
temperature is between 8 and 25°C.
! Caution: Make sure that the water level is lower than the maximum indication. If the water tank
is filled above the MAX indication, drain the excess water through the drain hole at the bottom of
the ice cube maker. Open the drainage hole on the underside of the appliance above a collecting
container or a sink.
3.
Place the basket back into the appliance and close the transparent lid.
4.
Plug the power cord into a socket. The 'small ice cubes' indicator light will start flashing.
5.
Wait a few seconds until the water tray is in the start position behind the cold fingers. Press the on/
off button firmly to turn the appliance on.
6.
The 'small ice cubes' and 'large ice cubes' indicator lights will flash alternately. You are now in the
selection mode to choose the size of the ice cubes. When the light of the desired ice cube size
flashes on, press the on/off button to confirm your selection.
7.
The indicator lamp will illuminate steadily and the ice-making cycle will start.
8.
A cycle lasts 6-8 minutes on average, depending on the ambient temperature. When a cycle is
complete, the ice cubes will be in the ice basket. The next cycle will start automatically. To stop the
appliance, press the power button. Pull the plug out of the power socket.
Clean the appliance after each use. Empty the water reservoir before storing the appliance. Open the
drainage hole on the underside of the appliance above a collecting container or a sink.
! During the first 3 cycles, the ice cubes may be smaller and more irregular in size. When the ice basket
is full, immediately remove the ice from the ice basket.
●
If the 'water reservoir empty' indicator lamp lights up, there is not enough water left in the water
ADD WATER
reservoir. Fill the water reservoir with water and press the on/off button to restart the machine.
38
DO1108IB
Publicité
