AENO SEASONAL AGH0001S Guide De Démarrage Rapide page 9

ENG
GENERAL INFO
Model
Specification
1
Casing
Functions
2
Scope of supply
Warranty
LED INDICATOR STATUSES
Blue
Green
Red
Purple
POWER BUTTON FUNCTIONS
Press and hold the power button:
 For less than 3 seconds to turn the heater on or off;
 For 4 to 9 seconds to switch the heater to the Wi-Fi pairing mode;
 For more than 10 seconds to reset the heater to the factory settings.
COMPONENTS AND ACCESSORIES (See Figure A)
Power button ❶ , control unit ❷ , heat-emitting panel ❸ , mounting brackets ❹ , power cord ❺ , legs for floor
installation ❻ , fastening bolts ❼ , temperature sensor ❽ , hooks with dowels (for wall mounting) ❾ , hole
drilling template ❿.
INSTALLATION AND CONFIGURATION
1. Unpack the heater and place it on a clean, horizontal surface with its heat-emitting panel facing down.
2. Install the heater as follows:
a. Floor installation (See Figure B):
NOTE. Only horizontal installation is possible.
 Screw legs ❻ to the back of the heat-emitting panel using fastening bolts ❼ (See Figure B-1);
ATTENTION! Correct orientation of legs must be observed (See Figure B-2)!
 Make sure that screws are securely tightened and that legs are correctly oriented relative to the device
body.
b. Wall mounting (See Figure C):
NOTE. Horizontal or vertical wall mounting is possible.
 Screw mounting brackets ❹ to the rear surface of the heat-emitting panel using fastening bolts ❼
(See Figure C-1);
ATTENTION! Correct orientation of brackets must be observed (See Figure C-2 for horizontal mounting
and C-3 for vertical mounting)!
aeno.com/documents
White: AGH0001S (Plug Type E/F), AGH0001S-IT (Plug Type L), AGH0001S-CH (Plug
Type J), AGH0001S-UK (Plug Type G), AGH0001S-SA (Plug Type M)
Black: AGH0002S (Plug Type E/F), AGH0002S-IT (Plug Type L), AGH0002S-CH (Plug
Type J), AGH0002S-UK (Plug Type G), AGH0002S-SA (Plug Type M)
Support of Wi-Fi (2.4 GHz), supply voltage: 230 (180-253) V AC, 50 Hz, input current: 3.0 A
(≤0.01 A in standby mode), nominal power: 700.0 W, (≤2 W in standby mode), heating
area of up to 30 m (depends on the room insulation), temperature sensor, tilt sensor
2
IP44 Protection Class, heat-emitting panel (tempered glass), control unit (PC plastic).
Dimensions: 1000×165×417 mm (floor installation), or 1000×62×365 mm (wall mounting)
Climate control, panel temperature control (up to 120 °С), manual and remote control,
current protection, voltage protection and overheating protection, voice assistants,
LED indication of statuses
Premium Eco Smart Heater, legs (2 pcs.), mounting brackets (2 pcs.), mounting kit, hole
drilling template, Quick Start Guide, Warranty Card
3 years (Service life: 3 years)
Blue
Green
Red
Yellow
3
Reset to factory settings
Indicator is on
Indicator is blinking
Indicator is blinking 3 times
The device is connected to the power source
The device is activated in the mobile app
The device is in the Wi-Fi pairing mode
The maintained room temperature mode is on
The heating mode is on
The heating mode is off
The device is overheated
9