Publicité
Product Use
Installation Concerns
DO NOT install this child restraint on vehicle seats with Lap Belts only. (1)
This child restraint is suitable for vehicle seats with a 3-point Retractor Safety
Belt. (2) This child restraint is suitable for vehicle seats with ISOFIX anchorage
bars when used with a base. (3)
DO NOT use the rearward facing systems in seating positions where an active
frontal airbag installed. (4) Death or serious injury may occur. Please reference
vehicle owner's manual for more information.
DO NOT install this child restraint on vehicle seats that face sideways or
rearward with respect to the moving direction of the vehicle.
Please refer to your vehicle owner's manual for recommended or suggested
installation positions.
It is recommended to install this child restraint on the rear vehicle seat. (4)
DO NOT install the child restraint on a movable vehicle seat that cannot be
locked.
Canopy
1
- To open the canopy, gently pull it forward to the back. To close, gently push
it back into place. (5)
2
- The canopy window can be opened for ventilation. (6)
Handle Adjustment
1
- The handle of the infant carrier can be adjusted to 2 positions. (7)
Position for car, hand or stroller transportation (7)-1. Baby chair position
(7)-2.
2
- To adjust the handle, press handle adjustment buttons on both sides (8)-1,
and then rotate the handle until it clicks into any of the 2 positions. (8)-2
Head Support Height Adjustment
Please adjust the head support and ensure the shoulder harnesses are
at the correct height. The shoulder harnesses should be level with or just
below the top of your child's shoulders. (9)(10)
9
ARRA flex instruction
If the shoulder harness straps are not at the proper height, the child might
be ejected from the enhanced child restraint in the event of a crash.
Pull the head support adjustment lever (11), and move the head support up or
down until it snaps into one of the 10 positions. The head support positions are
shown in (12).
Backrest Adjustment
There are 3 recline angles for the backrest.
Squeeze the backrest adjustment button (13) to adjust the backrest up and
down. (14)
Securing Child in the Enhanced Child Restraint
The infant insert enhances side impact protection for
children. We recommend using the infant insert when the
baby is under 60cm or until they outgrow the insert.
Make sure the infant insert already has the foam wedge in
it before using the insert.
Remove the infant insert when your child's shoulders no
longer fit comfortably.
1
-
Press the harness adjustment button while pulling the shoulder harness to
the desired length.
(15)
2
-
Unlock the buckle of the harnesses by pressing the red button. (16)
3
-
Place the child into the child restraint and lock the buckle. (17)(18)
4
- Pull down the adjustment webbing and adjust it to the proper length to
make sure your child is properly secured. (19)
Make sure the the shoulder harness straps are snugly tightened. Any belt
slack reduces the safety performance of the child restraint system.
Installation using 3-point-belt
DO NOT install this infant carrier module on vehicle seats that are only
equipped with a 2-point safety belt. (20)
1
- Place the infant carrier on the chosen vehicle seat. (20)
2
- Pull out the vehicle safety belt and lock it into the vehicle buckle. (21)-1
ARRA flex instruction
10
Publicité
