Publicité
4.
Turn on the appliance:
Hold the plug and pull out the cord, then insert the plug into the power socket. Make sure that the power
supply corresponds to the required power mentioned on the rating label. Press the on/off switch pedal to
turn on the power. Rotate the power control knob. Adjust the power to the required level depending on
the cleaning function.
5.
Turn off the appliance:
After using, press the on/off switch pedal, the appliance is turned off. Pull the plug out of the power
socket; press the cord pedal, the power cord will be drawn in.
6.
To move the appliance from room to room, unplug and carry it by using the handle. Never pull the
appliance by its cord when moving.
Tip: By reducing the suction power you can move the floor brush easier on the floor. Set the suction power to
minimal for furniture, to medium for carpet and hard floors. Only use the maximum setting on hard floors in
combination with a brush for hard floors.
MAINTENANCE
When the dust full indicator turns to red, it is time to clean the dust bag or replace with a new bag. To do that,
please follow the instructions:
a)
Open the front cover by pressing the lock clip.
b)
Remove the dust bag.
c)
Then take a new one, insert it into the appliance.
d)
Close the front cover.
NOTE:
1.
The front cover cannot be closed unless the dust bag is installed in right position.
2.
The motor protection filter (A) should be removed and rinsed twice a year or whenever it is visibly
clogged. If the filter is damaged, a new filter should be replaced.
- 14 -
Publicité
