Publicité
Charging the battery (fig. D)
• Make sure that the appliance is switched
off. The battery will not be charged with
the on/off switch (4) in the on position.
• Place the appliance on the charging
base (7) as shown. The charging indicator
wil be lit.
• Plug in charger and leave the appliance
on charge for at least 24 hours.
While charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
The charging indicator will be lit as long as
the appliance is connected to the
plugged-in charger.
wARNING:
below 39°F (4°C) or above 104°F (40°C).
Switching on and off (fig. E)
• To switch the appliance on, slide the on/
off switch (4) forward to position I.
• To switch the appliance off, slide the on/
off switch (4) back to position 0.
Optimizing the suction force
Rotating the bowl (fig. A) agitates the filter
to remove dirt; however, in order to keep the
suction force optimized, the dust container
and filters must be cleaned regularly.
Cleaning the dust container and
filters (fig. f - J)
There are two methods of cleaning
the bowl, a quick empty method and a
thorough clean method.
For the quick empty method use the following instructions.
• Press the release latch (6) and open the container door (5) (fig. F).
• Empty the dust container (11).
• Close the dust container door (5). Make
sure that the release latch (6) clicks into place.
For the thorough clean method use the
following instructions.
• The dust container (11) is attached to
the body of the appliance. To remove the
dust container, press the dust container
release button (2) and rotate the dust
container (11) counterclockwise and
carefully slide the dust container clear of
the appliance.
• Rotate the filter (12) within the pre-filter
(13) to agitate it and remove dirt.
• Remove the main filter (13).
D
Do not charge the battery at ambient temperatures
E
F
5
Publicité
