• This appliance is intended for household use only and not for commercial or industrial use.
• Shock Hazard. To protect against risk of electrical shock, do not put unit or charging base in
water or other liquid.
• Do not allow the cord to hang over the edge of a table or counter or touch hot surfaces. The unit
should be placed or mounted away from sinks and hot surfaces.
• Plug the charger directly into an electrical outlet.
• Use the charger only in a standard electrical outlet (120V/60Hz).
• Unplug the charger from outlet before any routine cleaning or maintenance.
• This product includes rechargeable nickel cadmium batteries. Do not incinerate batteries as
they will explode at high temperatures.
• Leaks from battery cells can occur under extreme conditions. If the liquid, which is a
20-35% solution of potassium hydroxide, gets on the skin (1) wash quickly with soap and water
or (2) neutralize with a mild acid such as lemon juice or vinegar. If the liquid gets into the eyes,
flush them immediately with clean water for a minimum of 10 minutes. Seek medical attention.
• Do not look into the air vents when the unit is switched on, as sometimes
there is a possibility of small debris being discharged from the air vents, especially after cleaning
/ replacement of the filters as debris inside the unit can be disturbed.
SAVE THESE INSTRUCTIONS
Symbols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ..direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gauge. The smaller the gauge number, the heavier the cord.
Volts
120V
240V
Ampere Rating
More
Than
0
6
10
12
Minimum Gauge for Cord Sets
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
Than
-
6
18
-
10
18
-
12
16
-
16
14
A ...................amperes
W ..................watts
or AC .......alternating current
n o .................no load speed
..................earthing terminal
................safety alert symbol
.../min or rpm........ revolutions or reciprocation
Total Length of Cord in feet
26-50
51-100
51-100
101-200
American Wire Gauge
16
16
16
14
16
14
12
Not Recommended
3
per minute
101-150
201-300
14
12
12