Twin-Star International Duraflame 19HM40204-E451 Manuel D'utilisation page 6

OPERATION INSTRUCTIONS
FUNCTION
NIGHT MODE
COOL DOWN CYCLE
SAFER PLUG™
Patent Pending
SAFER SENSOR™
Patent Pending
A648
ICON DESCRIPTION
Pressing this button will turn on/off the night mode setting.
Turning on night mode reduces the halogen and reduces the
brightness of the heater for night use.
" " will appear on the display.
Before the heater powers off, the fan will continue to run for a
period of time to cool down the internal parts.
This product is equipped with a Safer Plug™; an advanced safety
device that helps detect electrical fires caused from faulty outlets.
Overloading of outlet, adapters and surge protectors may cause
overheating, damage, and increase risk of fires. Safer Plug
continuously monitors the temperature in the plug and outlet
and will turn off the heater to prevent unsafe outlet overheating.
If the Safer Plug cuts the power due to unsafe conditions it will
show an "
Plug has prevented a potentially unsafe condition.
To reset the device if this occurs, first allow the plug to cool down.
Once the plug has cooled down, unplug the device and wait
5 seconds, then plug back in and continue to use normally.
If the Safer Plug continues to activate your outlet may be faulty.
Check your heater cord and plug connections. Faulty wall outlet
connections or loose plugs can cause the outlet or plug to
overheat. Be sure the plug fits tight in the outlet. Heaters draw
more current than small appliances, so overheating of the outlet
may occur even if it has not occurred with the use of other
appliances. During use check frequently to determine if your plug,
outlet or faceplate is HOT! If so, discontinue use of the heater
and have a qualified electrician check and/or replace the faulty
outlet(s).
This product is equipped with a Safer Sensor™; an advanced
safety device that helps prevent heaters from being accidently
covered or blocked causing a potentially unsafe condition.
The SAFER SENSOR detects if an object is too close to the front
of the heater potentially obstructing the air outlet. If blocked, the
SAFER SENSOR icon on the control panel will flash, the heater
will beep continuously, and then shut off. Once the object has
been moved, the icon will stop flashing, the beeping will cease,
and the heater will turn back on.
To disable the Proximity Sensor safety function press and hold
the ECO MODE button for 10 seconds. Once disabled the SAFER
SENSOR icon will remain lit indicating it is disabled. Repeat this
step to re-enable the function.
"message on the screen. If this occurs the Safer
6
www.tsicustomerservice.com