Publicité
7.5
Inner & Outer paddle
Both inner and outer paddle have a different speed range:
Inner paddle
Outer paddle
It is possible to change speed when the machine is running, with use of the speed dial (3).
7.6
Use of mix tool adapter
To operate with M14 Paddles, install the mix tool adapter (11) on the motor shaft (6). Make
sure both the adapter(11) and the Paddle (10) are properly screwed for further utilization.
8 MAINTENANCE AND CLEANING
Attention !Before performing any work on the equipment, pull the power
plug.
8.1
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9 TECHNICAL DATA
voltage / frequency
Power:
No-load speed:
Inner Paddle
Outer Paddle
Mixer diameter:
10 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration)
11 SERVICE DEPARTMENT
Damaged switches must be replaced by our after-sales service department.
If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).
Copyright © 2017 VARO NV
290 min-1 to 480 min-1,
380 min-1 to 620 min-1
POWX089
230V / 50 Hz
1600W
290-480 min-1
380-620 min-1
140 mm
POWX089
88 dB(A)
99 dB(A)
2,3 m/s²
P a g e
| 6
K = 1,5 m/s²
www.varo.com
EN
Publicité
