Publicité
This appliance is not suitable for mixing edible things. The appliance cannot be adequately
cleaned in order to comply with hygiene regulations.
7 OPERATION
7.1
Preparation((Fig 2)
Always unplug the machine from the mains before fitting a mixer bar.
First take the paddle (10) and screw the hexagon top it into the motor shaft (6). If the paddle
(10) fits well, tighten it and the motor shaft (6) as well. Make sure to use the right spanner (9)
for the right part, otherwise you can cause damage. Use one of the spanners to hold the motor
shaft in place and than use the second spanner to tighten up the paddle (10) Proceed in the
reverse sequence to undo the paddle (10) from the tool holding fixture (6).
Always use a mixer bar that is suitable for the material to be mixed/stirred.
Using an unsuitable mixer bar can unnecessarily overload both the
machine and yourself.
7.2
Switching on and off
To switch the tool on, press the switch (1), hold it down and push button (2). To switch the tool
off, release the switch (1) and button (2)
7.3
Continuous operation
Continuous operation can only be executed by continuous pressing the on/off switch (1)
7.4
Speed preselection
The speed can be preselected steplessly with the speed controller (3).
The necessary speed depends on the type of material you wish to mix; we recommend prac-
tical testing to determine the right speed.
Level 1
min. power=SLOW
Level 6
max. power=FAST
Copyright © 2017 VARO NV
POWX089
To remove the mixer bar, unscrew it from the mixer
spindle in an anticlockwise direction. The mixer bar can
become rather tight in the holder. In that case, use a spanner
to keep the holder from turning.
P a g e
| 5
EN
www.varo.com
Publicité
