Télécharger Imprimer la page

Altec Lansing FX5051 Mode D'emploi page 5

Publicité

Les langues disponibles

Les langues disponibles

Stand-By/Mute
To mute the speaker system, press the
control pod or wireless remote. The LED on the control pod will turn
off. To un-mute, perform either command again.
Note: While in stand-by or mute mode, the system continues to receive
power. To completely shut down the unit unplug the unit from the
wall.
Reset
The button marked with the word "reset" on the wireless remote
restores master volume, bass, treble, as well as center and rear volume
to original factory settings.
You can also reset the system by pressing the stand-by button
the controller for 5 seconds.
System Specifications*
Altec Lansing's superior sound comes from our patented Dynamic EQ technology, which utilizes custom-built, high-fidelity drivers, state-of-the-
art equalization circuitry, and a harmonious mix of the following specifications:
Sound Pressure Level (SPL):
Total Continuous Power:
• Front Speakers:
• Rear Speakers:
• Center Speaker:
• Subwoofer:
*Power rating conforms to FTC Amplifier Rule #16 C.F.R. Part 432.
button located on the
101 dB
89 Watts RMS
12 Watts/channel @ 4 ohms
@ 10% THD @ 150 Hz – 20 kHz
2 Channels Loaded
12 Watts/channel @ 4 ohms
@ 10% THD @ 150 Hz – 20 kHz
2 Channels Loaded
13 Watts @ 4 ohms
@ 10% THD @ 150 Hz – 20 kHz
Single Channel Loaded
28 Watts @ 8 ohms
@ 10% THD @ 40 – 150 Hz
Single Channel Loaded
Pod/MP3 Player Jack
I
The iPod or MP3 player jack is located on the side of the control pod.
Use it to connect any audio source that has a stereo 3.5mm plug.
Caution: Make sure the audio source features a line-out jack. This will
ensure that the output is not amplified. Check the owner's manual for
your audio device for more information.
Headphones
The headphone jack is located on the side of the control pod. Use it to
connect any stereo headphones with a 3.5mm plug.
Note: When headphones are connected, the speaker system is muted.
on
Frequency Response:
Signal to Noise Ratio
@ 1 kHz input:
Drivers (per satellite):
Subwoofer:
6
30 Hz – 20 kHz (-10 dB)
> 75 dB
One 40mm mid-range driver and
one 18mm high-end tweeter
Two 6.5" long-throw woofers
in isobaric configuration

Publicité

loading