Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Mount the heater support bracket to the gas cylinder. (see figure 2)
Figure 2
Apply the bracket to the flange of the gas cylinder as shown in Figure 2.1 and tighten the
knob.
Turn knob clockwise to tighten.
Figura 2.1
After attaching the bracket the gas cylinder, make sure:
•
THE BRACKET IS CONNECTED GOOD AND FIRM TO THE GAS CYLINDER.
•
THE WHOLE CONSTRUCTION IS STABLE!
INSTALLING THE FLOOR STANDING HEATER (FGHX)
Open the stand bracket and place the heater on an even, flat floor.
USE
The knobs for turning the gas heater ON are located on the upper part of the heater:
•
Open the gas container (follow the user instructions provided with the low-pressure regulator).
Figure 3
1. ODS
2. Safe guard
3. Cover
4. Control knob
5. Ignitor
4
34
Publicité
Table des Matières
