Doro HandleEasy 321rc Mode D'emploi page 2

HandleEasy 321rc is an easy-to-use remote control featuring large
buttons.
Batteries
HandleEasy uses three 1,5V AAA batteries. When the batteries are
running low, the indicator will flash three times when pressing a button.
Only use high quality batteries. Insert the batteries according to the
markings for plus and minus terminals under the cover at the back.
Programming buttons
In order for HandleEasy to work together with your equipment, it must
be 'taught' the signals that are sent from the remote control of the
equipment. HandleEasy can also be taught the signal of other remote
controls from different equipment i.e. channel browsing from the TV and
audio volume from the stereo.
1. Keep the ON and OFF buttons depressed for about 3 seconds.
The indicator will show a steady light (if no button is depressed
within 10 seconds, the learning mode will be cancelled).
2. Press the desired button on HandleEasy. The indicator will flash once.
3. From a distance of approx. 1 in. to 4 in., point the remote control
of the equipment towards HandleEasy (so that the signal points
of both remote controls are facing each other) and press the
corresponding button. If HandleEasy was successful in learning
the signal, the indicator will flash twice. If there is an error, the
indicator will flash six times. If necessary hold down the button of
the equipment for up to 10 seconds to succeed with the learning.
4. After pairing wait for 10 seconds before testing the programmed
button or hold down the ON and OFF buttons until the indicator
goes out.
Repeat steps 2 and 3 for each button, or if the learning fails.
Repeat steps 1 and 3 if a button needs to be altered.
Programming, button with double signal
Certain remote controls send different signals every other time a
button is pressed, a double signal. If you experience that HandleEasy
only works now and then or jumps double steps it is likely that the
original remote control utilizes a double signal. To teach HandleEasy
this double signal, follow the instructions below.
1. Keep both ON and OFF depressed for about 3 seconds. The
indicator will show a steady light (if no button is depressed within
10 seconds, the learning mode will be cancelled).
2. Press the desired button on HandleEasy. The indicator will flash
once.
3. From a distance of approx. 1 in. to 4 in., point the remote
control of the equipment towards HandleEasy and press the
corresponding button. If HandleEasy was successful in learning
the signal, the indicator will flash twice. If there is an error, the
indicator will flash six times. If necessary hold down the button of
the equipment for up to 10 seconds to succeed with the learning.
English