Publicité
Les langues disponibles
Les langues disponibles
Display layout
The measured temperature will be shown on the OLED* display when pressing one of
the two lower buttons or when clicking the hidden button on the top centre of the glass
panel.
The target temperature (underlined) can be set using the lower two buttons (next to the
small down/up arrows on the OLED* display).
If your system is heating, the LED at the up arrow will be lit, if your system is cooling, the
LED at the down arrow is lit!
After 3 seconds, it shifts back from showing the set temperature to the measured
temperature.
100 and below = no action needed
150 = low speed
250 = medium speed
350 = high speed
450 = high speed + we recommend having an alarm message (e.g. a number of beeps + a
text message on a touch screen).
The VOC index is measured in AURUS-6 TEMP touch panel (in the lower part on the
backside of the glass panel).
The Clean mode will be activated when you press at least about 1.5 seconds on the
hidden button on the top center part of the glass front plate. In cleaning mode, all six
Air humidity percentage can be displayed by a second click on
the upper-central hidden button (see drawing). It's a percentage of
relative air humidity in the direct surroundings of the touch panel
(the sensor is built-in in the panel).
The VOC index (air quality index) can be displayed by a third click
on the upper-central hidden button (see drawing). The following
values are interesting to know since your ventilation system is most
likely
pre-
configured
Page 4 of 30
by
your
system
EN
integrator:
Publicité
