Télécharger Imprimer la page

Fantini Rubinetti ABOUTWATER AC/ECLIPSE L700BU Instructions De Montage

Masquer les pouces Voir aussi pour ABOUTWATER AC/ECLIPSE L700BU:

Publicité

Liens rapides

AC/ECLIPSE
Instructions / Instructions De Montage / Instrucciones
ART. L700BU
ART. D900AU

Publicité

loading

Sommaire des Matières pour Fantini Rubinetti ABOUTWATER AC/ECLIPSE L700BU

  • Page 1 AC/ECLIPSE Instructions / Instructions De Montage / Instrucciones ART. L700BU ART. D900AU...
  • Page 2 NECESSARY TOOLS - OUTILS NÉCESSAIRES - HERRAMIENTAS NECESARIAS 10 mm TECHNICAL DETAILS - DONNÉES TECHNIQUES - DATOS TÉCNICOS Minimum pressure Pression minimum Pression mínima 1 BAR Minimum pressure Pression maximum Pression máxima 10 BAR Reccomended working pressure Pression optimale de service Pression de trab.
  • Page 3 TECHNICAL DETAILS - DONNÉES TECHNIQUES - DATOS TÉCNICOS If water pressure is above 5 bar, it is advisable to install a flow restrictor upstream of the water supply to avoid vibrations and regulate temperature. Si la pression de l’ e au est supérieure à 5 bar, il est recommandé d’installer un réducteur de pression en amont de l’alimentation afin d’...
  • Page 4 PRE-INSTALLATION - PRÉ-INSTALLATION - PREINSTALCIÓN D900AU+L700BU 3-1/8" 3-3/4" 3-1/8" 3-3/4" 4-1/4" 2-3/4" 3-5/8" ↑ 1/2" NPT 4-1/4" 2-3/4" 3-5/8" ↑ 1/2" NPT ↑ ↑ 1/2" NPT 1/2" NPT 3/4" 1-3/8" ↑ ↑ 1/2" NPT 1/2" NPT 3/4" 1-3/8" These mixers can be used with high-pressure hot water accumulators or with instant water heaters. Ces mitigeurs peuvent être utilisés avec des accumulateurs d’...
  • Page 5 INSTALLATION - INSTALLATION - INSTALACIÓN minimum depth /profondeur minimale / profundidad mínima maximum depth / profondeur maximale / profundidad máxima Edge of the tiling Fil revetement Borde revestimiento Edge of the tiling Fil revetement Borde revestimiento •Put the system under pressure in order to verify the hold and correct installation •L’installation sous pression pour en vérifier l’...
  • Page 6 INSTALLATION - INSTALLATION - INSTALACIÓN...
  • Page 7 INSTALLATION - INSTALLATION - INSTALACIÓN ø 8mm...
  • Page 8 INSTALLATION - INSTALLATION - INSTALACIÓN...
  • Page 9 INSTALLATION - INSTALLATION - INSTALACIÓN Please note, screw and dowel are NOT supplied, they must be chosen according to the support. Nota bene, les vis et les chevilles NE sont PAS fournies, elles doivent être choisies en fonction du support. Tenga en cuenta que los tacos y tornillos NO suministrados deben elegirse de acuerdo con el soporte.
  • Page 10 INSTALLATION - INSTALLATION - INSTALACIÓN 1/2” 1/2” TEFLON...
  • Page 11 INSTALLATION - INSTALLATION - INSTALACIÓN INLET TEST ESSAI ENTRÉES PRUEBA DE LAS ENTRADAS MIN 5 Bar Max 10 Bar...
  • Page 12 INSTALLATION - INSTALLATION - INSTALACIÓN...
  • Page 13 INSTALLATION - INSTALLATION - INSTALACIÓN 2 mm...
  • Page 14 INSTALLATION - INSTALLATION - INSTALACIÓN...
  • Page 15 INSTALLATION - INSTALLATION - INSTALACIÓN 2 mm 2 mm...
  • Page 16 - UTILISATION - USO 38°C PUSH...
  • Page 17 - UTILISATION - USO On first use or following prolonged periods of inactivity, do not use the first half-litre of drinking water dispensed. Shut off the plumbing system in the event of a long absence. Check the water-tightness regularly. Lors de la première utilisation ou après une longue période de non utilisation, ne pas consommer le premier demi-litre d’...
  • Page 18 CARTRIDGE REPLACEMENT - REPLACEMENT DE LA CARTOUCHE - SOSTITUTION DEL CARTUCHO 2 mm...
  • Page 19 CARTRIDGE REPLACEMENT - REPLACEMENT DE LA CARTOUCHE - SOSTITUTION DEL CARTUCHO 35 mm • Replace following the instructions in reverse order (6-5-4-3-2-1). • Re-installer au contraire du procédé (6-5-4-3-2-1). • Colocar según el procedimiento inverso (6-5-4-3-2-1).
  • Page 20 Fratelli Fantini SpA via Buonarroti, 4 28010 Pella (NO) Italia T +39 0322 918411 r.a. F +39 0322 969530 www.aboutwater.it www.fantini.it fantini@fantini.it...