Publicité
APPLIANCE PARTS
1. ON/OFF switch
ES
2. LED display
3. Shift button
4 Connector
PT
5. Air outlet
EN
OPERATION
▶Plug the heater into the 220-240V~ 50Hz AC outlet.
FR
NOTE
▶Once you turn off the heater it will only stop the heating process but
the fan will continue to run for approximately 99 seconds to allow
the internal components to cool down. Afterwards the fan will turn
off automatically.
▶The heating capacity is 8 square meters.
▶The heater must be placed facing up (the control panel is on top).
▶The distance between the bottom of the heater and the floor must be
more than 30 cm.
▶The distance between the side of the heater and the wall or any other
object should be more than 50 cm.
▶Press the "ON/OFF Button" on the side of the unit to turn the heater
on.
▶Press and hold the mode button "
(0-12 hours).
▶Press the "+" button to increase the temperature.
▶Press the "-" button to decrease the temperature.
▶Press "
" button to select high and low fan speed setting.
▶When finished, press the mode button "
NOTE
▶The product will work continuously unless the timer has been set or
it is turned off.
▶When turning off the heater, the heater will stop the heating process
immediately.
▶If you do not use the appliance for a long time, unplug the power
cord from the electrical outlet.
▶Never try to disassemble the device.
▶If you notice any abnormality (such as unusual noise from the
device), turn off the device and unplug it immediately.
▶Do not use this heater with a programmer, timer or other device that
switches the heater on automatically, as there is a risk of fire if the
Instruction manual
" to use the timer function
" to turn it off.
heater is covered or positioned incorrectly
▶Make sure that no objects or liquids get inside the appliance through
the openings.
▶The device must only be used in dry environments. Do not use in the
immediate vicinity of a bathtub, shower or swimming pool
▶Protect the device from dust, moisture, sunlight, and direct heat.
EXCESSIVE HEATING
▶The thermostat will shut off the machine when it overheats.
▶Overheating can be caused by obstruction of the air inlets/outlets at
the rear of the machine or the grill at the front. If this occurs, unplug
the machine and allow it to cool down for 30 minutes. Remove any
obstruction and restart the machine.
CLEANING AND MAINTENANCE
▶There are no parts inside the machine that require your attention or
service. Do not try to open the outer casing. Doing so could damage
the motor and heating element and void your warranty.
▶Make sure the appliance is unplugged before cleaning it.
▶Clean with a soft, slightly damp cloth, without detergent, aggressive
liquids or solvents. Never clean the machine with water and do not
allow it to get wet under any circumstances.
▶Do not immerse the appliance in water or any other liquid.
▶If the appliance is not going to be used for a long period of time,
protect it and store it, or after cleaning it, in a dry place.
Ref. 07187
Publicité
