Publicité
STEP 30
ameriwoodhome.com
12
(x1)
With the help of another person holding unit steady upright, take the
Loop Sensor (19c) that is connected to the Transformer (19a) and place
underneath Lower Shelf (K) at the hole location of the Touch Sensor Disk
(20). Thread screw (12) through the Loop Sensor and screw into Touch
Sensor Disk (20).
wire hole
F
K
19c
(x1)
Once screw (12) is fully tightened, thread the light
plug (19d) wires up along the back side of the unit.
Thread the wires through the wire hole in the
Upper Back Panel (F). Secure wires so they don't
fall behind the unit when attaching to the wall.
light plug wires (19d)
19c
39
19d
(x2)
wire hole
K
I
12
F
Publicité
