Publicité
TROUBLESHOOTING
INFLATOR DOES NOT TURN ON:
1. Check the power plug and push it firmly into the receptacle, twist back and forth.
NOTE: When the inflator is connected to power, the built-in LED light will automatically light up.
There is no switch for this light.
2. Check receptacle and plug terminals for dirt or debris. (Use a non-conductive probe, not fingers
or metal).
3. Check vehicle power
outlet fuse has not
blown. It should be 15A
minimum fuse circuit.
4. Check the inflator's
fuse located in the
plug assembly (Fig. 2).
Unscrew the tip, remove
fuse, and inspect.
NOTE: If the fuse has blown, replace fuse with 15A 250V fast blow fuse (5 x 20 mm), 1 is included.
5. Check for damage to the power cord. DO NOT USE if cord is damaged.
INFLATOR RUNS BUT DOES NOT INFLATE:
1. Be sure the air hose valve connector is fully secured on the tire valve.
2. Check tire for leaks, and check hose for breaks and leaks at fittings.
3. Check valve core for damage or debris.
INFLATOR RUNS SLOWLY:
1. The inflator may be overheated from excessive use. Shut off and allow to cool for 25 minutes.
2. Voltage too low. Check condition of vehicle battery and/or alternator.
NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim allowing air
to leak out when trying to inflate. In the event this occurs, you will have to jack up the tire prior to
inflation and reseat the tire onto the rim.
Dispose of this product at an e-waste recycling collection point or facility. Do not place in the trash
or standard recycling receptacle.
© Copyright 2024 WILMAR LLC., P.O. Box 88259 Tukwila, WA 98138
Fig. 2
ADAPTER BODY
COMPRESSION SPRINGS
SCAN QR CODE FOR MORE INFORMATION
TIP
FUSE
Publicité
