Publicité
How to Install
Side louvers and the rear of the air conditioner must have clear air space to allow enough airflow through the
condenser, for heat removal. The rear of the unit must be outdoors, not inside a building or garage. There should be
at least 11.8 inches (300mm) clearance around the unit. See FIG. 4C & FIG. 4D.
FIG. 4C
11.8" min (300 mm)
11.8" min
(300 mm)
11.8" min (300 mm)
Outdoor side
Storm Window:
If the air conditoner is blocked by Storm Window, add wood as
shown in FIG. 5, or remove storm window before air conditioner
is installed.
If Storm Window Frame must remain, be sure the drain holes or
slots are not caulked or painted shut. Accumulated Rain Water
or Condensation must be allowed to drain out.
Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air
conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail
of the unit.
FIG. 6A
INSIDE
Extend the side panels out against the window frame (FIG. 7A for wooden windows), (FIG. 7B for Vinyl-Clad
windows).
FIG. 7A
11.8" min (300 mm)
11.8" min
(300 mm)
11.8" min (300 mm)
Indoor side
OUTSIDE
W
o
o
d
e
n
W
n i
d
o
w
s
window
frame
FIG. 4D
11.8" min
Outdoor side
(300 mm)
11.8" min
Indoor side
(300 mm)
Storm window
frame or other
obstruction.
FIG. 6B
N I
S
D I
E
FIG. 7B
Installation
11.8" min
(300 mm)
11.8" min
(300 mm)
FIG. 5
SASH
Board
thickness as
1-1/2" min
required, for
(38 mm)
proper pitch to
rear, along
entire sill.
Fasten with
nails or screws.
O
U
T
S
D I
V
n i
l y
C -
a l
d
3
E
W
n i
d
o
w
s
Publicité
