Publicité
Les langues disponibles
Les langues disponibles
Using 2-Conductor Wire or Low-Voltage Lighting Wire
1.
Unwind the 2-conductor wire spool towards the amplifier from
the furthest speaker, leaving the wire attached to the spool at
the amplifier end. Do not connect the wires to the amplifier at
this time.
2.
Starting at the speaker furthest from the amplifier, strip 3/4" of
insulation on the cut end of the burial wires for the appropriate
amp channel according to the tables below, then strip
insulation from the ends of the corresponding speaker's pigtail
(see Figure 7).
3.
Connect the burial cable to the speaker pigtail using a wire tie
(see Figure 7).
4.
Twist to combine all the positive (+) wires together and
combine all the negative (-) wires together according to the
tables below.
5.
Twist the provided silicone-filled wire nuts onto the combined
positive wires and onto the combined negative wires, ensuring
that no copper is exposed. Wrap each wire nut connection in
electrical tape to protect it from moisture.
6.
Leave 14-16" of excess wire at the speaker so that the wire
doesn't kink or pull taut during burial, then move to the next
speaker of the same channel (left or right) along the cable.
7.
At the next speaker, use a round cable stripper or utility knife
to remove 8" of the outside wire jacket, exposing the two
insulated wires.
8.
Cut the two wires for the left or right speaker (see the tables
below) and strip 3/4" of insulation on the exposed ends of
the burial wires, then strip 3/4" insulation from the ends of the
corresponding speaker's pigtail (see Figure 8).
9.
Create a loop of approximately 10", and use a wire tie to hold the wire
loop and speaker pigtail in place to provide strain relief, as shown in Figure 8.
10. Repeat steps 4-6 for each remaining bollard speaker along the cable. For subwoofer installation, refer to the guide
included with the subwoofer.
11. Repeat steps 1-10 for the other amp channel.
Polarity Burial Wire Line 1 Speaker Pigtail
+
Positive
-
Negative
Left Amp Channel
Softscape Mount Installation
Use the three included softscape spikes to secure the
bollard in place (see Figure 9). See the instructions included
with the mounting template.
NOTE:
Be careful not to hit the bollard with the rubber
mallet as this can mar the painted finish. For precautionary
measures, we recommend wrapping the rubber mallet with
the large plastic bag that you removed from the bollard
before installing the spikes.
Polarity Burial Wire Line 2 Speaker Pigtail
Red
+
Black
-
_
+
FROM AMPLIFIER
Figure7
_
+
FROM AMPLIFIER
TO NEXT SPEAKER
Figure 8
Positive
Red
Negative
Black
Right Amp Channel
Figure 9
6
Publicité
