Stanley FATMAX FMHT77419 Mode D'emploi page 16

EN
WARRANTY
This instrument is warranted to be free from defects in material and
workmanship for a period of one year. Any instrument found defective
within one year from the delivery date and returned to the factory with
transportation charges prepaid, will be repaired, adjusted, or replaced
at no charge to the original purchaser. This warranty does not cover
expendable items such as battery or fuse. If the defect has been
caused by misuse or abnormal operating conditions, the repair will be
billed at a nominal cost.
SAFETY INFORMATION
This meter has been designed according to This should be IEC
61010-1:2010 concerning electronic measuring instruments with
a measurement category (CAT III 600V) and pollution degree 2.
Warning
To avoid possible electric shock or personal injury, follow these
guidelines:
• Do not use the meter if it is damaged. Before you use the meter,
inspect the case. Pay particular attention to the insulation surrounding
the connectors.
• Inspect the test leads for damaged insulation or exposed metal.
Check the test leads for continuity. Replace damaged test leads
before you use the meter.
• Do not use the meter if it operates abnormally. Protection may be
impaired. When in doubt, have the meter serviced.
• Do not operate the meter around explosive gas, vapor, or dust.
• Do not apply more than the rated voltage, as marked on the meter,
between terminals or between any terminal and earth ground.
• Before use, verify the meter's operation by measuring a known
voltage.
• When measuring current, turn off circuit power before connecting
the meter in the circuit. Remember to place the meter in series with
the circuit.
• When servicing the meter, use only specified replacement parts.
• Use caution when working with voltage above 30V ac rms, 42V
peak, or 60Vdc. Such voltages pose a shock hazard.
• When using the probes, keep your fingers behind the finger guards
on the probes.
• When making connections, connect the common test lead before
you connect the live test lead. When you disconnect test leads,
disconnect the live test lead first.
• Remove the test leads from the meter before you open the battery
cover or the case.
16