lidl BL BZBK 850 A1 Instructions D'utilisation Et Consignes De Sécurité page 14

˜ Attaching accessories
Connect the hose
1 ] [
hose must audibly lock in place (Fig . B) .
Insert the handle of the hose
wide opening of the telescopic tube
(Fig . C) .
Set the telescopic tube
length:
– Slide the telescopic tube lock
and adjust the length of the telescopic
tube (Fig . D) .
[ 2 ]
– Release the telescopic tube lock
– If necessary, slightly adjust the length until
the telescopic tube lock
Insert the telescopic tube
intake of the nozzle
brush (Fig . E) .
18 ] [
NOTES:
The nozzles
[ 15 ] 16 ] [
brush can be directly attached to the
18 ] [
hose .
1 ] [
Prior to usage: Ensure all accessories are
securely fastened .
The nozzle holder
telescopic tube
2 ] [
[ 19 ]
[ 2 ]
12 GB/IE/NI
with the intake . The
[ 13 ]
into the
1 ] [
[ 2 ]
to the desired
[ 2 ]
forward
[ 20 ]
.
[ 20 ]
locks in place .
20 ] [
into the
[ 2 ]
or furniture
15 ] [ [ 16 ] 17 ] [
and the furniture
[ 17 ]
can be attached to the
[ 19 ]
.
[ 17 ]
The following accessories can be attached to
the nozzle holder
– Upholstery nozzle
16 ] [
– Crevice nozzle
17 ] [
– Furniture brush
[ 18 ]
˜ Switching on/off
Pull the power plug
least until the yellow marking . When the red
marking appears, the end of the power cord
has been reached . Do not pull out the power
plug any further (Fig . F) .
Connect the power plug
outlet .
Switching on/off: Press the on/off switch
once (Fig . G) .
12 ] [
Disconnect the power plug
socket-outlet if you do not use the product .
Winding up the power cord
cable winder button
NOTE: Hold the power cord
hand . Guide the power cord while it is being
wound up .
˜ Increasing/decreasing
suction power
Adjust the suction power with the secondary
air regulator
[ 18 ]
[ 16 ]
when not in use:
19 ] [
out of the housing, at
9 ] [
to a socket-
[ 9 ]
from the
9 ] [
: Press the
9 ] [
(Fig . H) .
[ 7 ]
with one
9 ] [
(Fig . I) .
[ 22 ]