STEINEL IS 180 digi Mode D'emploi page 13

Unit does not switch OFF.
– Continued movement within the detection zone.
• Check detection zone.
• If necessary, limit or change detection zone.
Unit switches ON when it should not
– Movement within the detection zone, e.g. from
animals, trees or cars.
• Check detection zone.
• If necessary, limit or change detection zone.
– Unit is moving as a result of gusts of wind or
precipitation.
• Mount floodlight on a firm surface.
No connection being set up to sensor switch
from smartphone or tablet.
– Smartphone too close to sensor switch.
• Distance from sensor switch at least 1.5 m.
– The app is not compatible with the smartphone
or tablet.
• Use different smartphone or tablet.
– App version not up to date.
• Update Steinel Connect app in the app store.
No connection with the app.
– No network key on the smartphone or tablet that
is being used.
• Share network key via app.
9. Disposal
Electrical and electronic equipment, accessories
and packaging must be recycled in an environ-
mentally compatible manner.
Do not dispose of electrical
and electronic equipment as
domestic waste.
EU countries only:
Under the current European Directive on Waste
Electrical and Electronic Equipment and its imple-
mentation in national law, electrical and electronic
equipment no longer suitable for use must be
collected separately and recycled in an environ-
mentally compatible manner.
10. Declaration of Conformity
STEINEL GmbH hereby declares that the IS 180
digi sensor switch conforms to Directive 2014/53/
EU. The full wording of the EU Declaration of
Conformity is available for downloading from the
following Internet address: www.steinel.de
11. Manufacturer's warranty
Manufacturer's warranty of
STEINEL GmbH, Dieselstrasse 80-84,
DE-33442 Herzebrock-Clarholz, Germany
All STEINEL products meet the highest quality
standards. For this reason, we, the manufacturer,
are pleased to provide you, the consumer, with a
warranty under the following terms and conditions:
The warranty covers the absence of deficiencies
which are proven to be the result of a material
defect or fault in manufacturing and which are re-
ported to us immediately after detection and within
the warranty period. The warranty shall apply to all
STEINEL products sold and used in Germany -
excluding STEINEL Professional products.
You can opt for warranty cover in the form of
repair or replacement which will be provided free
of charge (if applicable, in the form of a successor
model of the same or higher quality) or in the form
of a credit note.
The warranty period for the STEINEL product you
have purchased is 3 years (5 years for products
from the XLED home range) in each case from the
date on which the product was purchased.
We shall bear the shipping costs but not the trans-
port risks involved in return shipment.
Statutory rights accruing from defects, gratui-
tousness
The warranty cover described here shall be appli-
cable in addition to the statutory rights of warranty
– including special consumer protection provisions
– and shall not restrict or replace them. Exercis-
ing your statutory rights in the event of defects is
gratuitous.
Exemptions from the warranty
All replaceable lamps are expressly excluded from
this warranty. In addition to this, the warranty shall
not cover:
– any wear resulting from use or any other natural
wear of product parts or any deficiencies in the
STEINEL product that are attributable to wear
caused by use or other natural wear,
– any improper or non-intended use of the product
or any failure to observe the operating instruc-
tions,
– any unauthorised additions, alterations or other
modifications to the product or any deficiencies
attributable to the use
of accessory,
– supplementary or replacement parts which are
not genuine STEINEL parts,
– any maintenance or care of products that is not
carried out in accordance with the operating
instructions,
– 13 –
GB