Publicité
Les langues disponibles
Les langues disponibles
V. OPERATION
5.1- Intended use
This cordless pressure washer is designed for cleaning bikes, garden furniture and other outdoor
items that require low to medium pressure water jet. The tool is not intended for artisanal,
commercial, professional and / or industrial use.
WARNING!
This tool must only be used with clean water. Use of waste water, corrosive or
flammable chemicals will damage the product.
5.2- Operation
Before use
• Inspect the general condition of the tool, hose and connections. Make sure they are not worn
or damaged or leaked.
• Make sure the tool is properly assembled as illustrated in Section 4.
• Make sure battery pack is sufficiently charged and properly installed.
Connecting to water supply
• Example of water supply is water tank, pond, rain barrel.
• Immerse the assembled suction hose into the water source. Make sure there is no
obstructions around the suction filter.
• Adjust the floating ball (11) in such a way that the suction filter (9) is at least 20 cm above
the bottom of the water source.
• Make sure there is no kinks in the hose (10).
• The pressure washer is now ready to use.
Switch the pressure washer ON/OFF
• Make sure the pressure washer is connected to sufficient water source. Dry running will
damage the tool.
• To start the pressure washer motor, press and hold the trigger release button (5) and pull the
switch trigger (4).
• To stop the tool, release the switch trigger (4).
Adjusting the spray patterns
• There are 6 spray patterns with the nozzle head (1). Simply turn nozzle head and select the
spray pattern that suits your application.
• Spray patterns: 0°, 15°, 25°, 40°, shower and angled water jet.
After use
• Allow the pressure washer runs with clean water for 2 mins in order to remove residuals that
may be accumulated in the tool or hose.
• Release the switch trigger (4) to stop the tool completely.
• Remove the suction hose (10) from the water supply.
• Remove the battery pack from the tool.
• Disconnect the suction hose and lance extension (2) from the machine.
• Press and hold the trigger release button (5) and switch trigger (4) to depressurize and drain
the system.
• Clean the product exterior surface with a dry clean cloth.
Page 13 / 22
Publicité
