Toolland FT92N Mode D'emploi page 6

8. Thermostatic Ignition
Prior to using the gas heater for the first time or after the gas heater has been stored for a
long time, we recommend, with the pressure regulator closed, repeatedly pressing the buttons
a few times.
Open the gas flow by turning the lever of the pressure regulator toward the marking.
Switching On the Gas Heater
 Fully turn the thermostat button in an anticlockwise direction until it reaches its maximum
position.
 Fully press the
 The pilot light will burn. Repeat the steps above if the pilot light dies out.
 Keep pressing the
leave the thermostat button at its maximum position for 10 minutes. When the room has
reached the ideal temperature, turn the thermostat button in the desired position.
9. Cleaning and Maintenance
In the unlikely event of technical problems or should you need spare parts, please contact your
dealer.
 Periodic maintenance must be done by a qualified technician only.
 We recommend servicing your gas heater every two years by a qualified technician.
 Regularly check the pilot light, which must burn steadily.
 Check if the gas hose must be replaced. If so, contact your dealer for a new hose and
connect as described in chapter Starting the Gas Heater.
 We recommend cleaning your gas heater only with a closed pressure regulator, after the
gas heater has cooled down completely, and using non-abrasive cleaning agents.
 Store an unused gas heater in a dry and dust-free room, covered with a plastic sheet or
cloth.
10. Troubleshooting
The gas heater does not switch on.
 Check if the gas cylinder is filled with gas and if the pressure regulator is correctly
connected and opened.
 Make sure the gas hose is connected. Please follow the instructions correctly.
 Presence of air in the gas cylinder. Keep pressing the button until the pilot light burns and
the gas heater is switched on. Next, turn the thermostat button to the maximum position.
 The gas cylinder has been exposed to low temperatures. Apply hot and damp cloths to the
upper part of the gas cylinder to enhance the gasification and the normal gas output.
The gas heater switches off.
 If the gas heater switches off after the switch-on procedure, simply repeat the procedure
minding every step described in the instructions.
 If the gas heater switches off after 30 minutes of burning, it might be due to a little-
ventilated room. Air the room where the gas heater is being used and switch on the gas
heater.
 If the gas heater switches off within 30 minutes of burning, check for draughts and verify
the gas level in the cylinder.
V. 05 – 04/07/2018
FT92N
button for 15 seconds, and then press the
button for 20 seconds to allow the thermocouple to heat. Release and
6
button 2 or 3 times.
©Velleman nv