Publicité
Les langues disponibles
Les langues disponibles
OTHER FUNCTIONS
Start/Stop : allows to stop any
•
blending or heating program
before the end by pressing this
button.
You can also stop the blending during
the cycle :
- within 1 minute of working, press the
start/stop button
- more than 1 minute of working, press
and hold the start/stop button for 3
seconds
CLEANING
• Clean the jug immediately after use.
• For easy cleaning, you can use the
Pulse/Clean button :
- Put 150ml of water and 1 drop of
washing up liquid in the jug. Press
the Pulse/Clean button.
An excess of washing up liquid creates
more foam and consequently can
lead to overflowing. Finish cleaning
the jug with the aid of a sponge.
• Rinse the inside of the jug and the lid
under running water.
• In the event of the heated part of
the jug getting extremely dirty, fill
in the jar with a mix of water and
washing up liquid and let it soaked
for a few hours to help get it clean.
• Use a damp cloth to clean the motor
unit (E). Dry it carefully.
• The detachable parts (lid, lid cap,
Overload protection
• The appliance is equipped with
overload protection. This prevents
the motor from being damaged by
overloading.
If the appliance switches off during
operation, proceed as follows :
- Switch the appliance off using the
power button, unplug and leave it to
cool down for approximately 15-20
minutes.
- Reconnect the appliance to the power
supply and resume blending.
carrier seal, seal, measuring cap)
can be cleaned with a sponge and
hot soapy water. You can also use
the brush to clean the inside of the
jug.
Caution:
• Empty the preparation, the jug is
not meant for storing food in the
refrigerator or freezer.
• To clean the outside of the motor
unit and the walls of the jug, use a
damp cloth.
• Do not immerse the appliance in
water (neither the motor unit nor
the jug base). Never put the motor
unit (E) under running water.
• The jug, lid cap and removable
silicone gasket must not go in the
dishwasher.
4
Publicité
