BEA 564DC Notice D'emploi page 13

Device-specific additional instructions for nailer
4 Filling the magazine
Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position
•
(Chap. 3): The driving nose must point away from any
person. It must be impossible to unintendly actuate trigger
and/or release protection.
Actuate the locking lever 1 on the head piece and open the
•
head piece flap 2. Then open magazine cover 3 and set coil
plate 4 to nail length. Insert nails into magazine. Then close
the magazine cover and headpiece flap
5 Removing stuck fasteners from the driving channel
Disconnect the tool from the compressed air supply. Open the magazine as described in chapter 4 and
•
remove the nails. Use pliers to remove jammed fasteners from the magazine. Then reconnect the tool to the
compressed air supply and refill it with nails
6 EU Declaration of conformity
The BeA GmnH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
564DC
.
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 13