Publicité
Les langues disponibles
Les langues disponibles
Wall mountable (screws and anchors included)
Water Detector with built in 105 dB alarm.(optional)
INSTALLATION
Unit must be installed where it has access to a land line and electrical outlet.
1. Remove the screw from battery cover of main unit, install 9V battery. This is a back-
up battery. This battery will keep the unit working in case of power failure. (Fig.1) Also
install 9V battery in the water detector (Fig.2.)
2. Raise the antenna on the side of the auto dialer and raise the antenna of the water
detector unit so it points up. (Fig.2&3) The antennas should be vertical for best reception.
WIRELESS WATER SENSOR
There are two parts in the sensor, the main unit and the sensor probe.
INSTALLATION (test range before permanently installing)
a. Mount the main unit at a desired location with hardware included.
b. Mount the sensor probe at desired location using its suction cup. (Fig.2)
OPERATION
a. The sensor is in standby mode once battery is installed.
b. The LED will flash and the siren will sound for 45 seconds once water is detected.
Slide the alarm switch to ON/OFF position for siren sound ON/OFF as desired. If
in OFF position the unit will still send signal to auto dialer if triggered, the unit
itself will not sound. ON/OFF switch is for internal alarm sound only.
3. The supplied telephone line splitter can be installed into your telephone wall socket.
(Fig.3a) or the LINE Jack of the auto-dialer (Fig.3b)
4. Using the telephone wire supplied, insert the small clear plug into the LINE jack on
the auto-dialer and the other end into the telephone line splitter, (Fig.3a) or insert your
telephone line splitter into LINE Jack of main unit, then plug telephone wire supplied
into wall socket. (Fig.3b)
Publicité
