Publicité
Les langues disponibles
Les langues disponibles
g. You will hear a long beep from the auto-dialer to confirm that learn was
successful and the screen will display FULL for that zone.
h. Press the PROG
NOTE: if you have learned a motion detector to your auto dialer, place a towel over the
motion sensor before learning other items as the motion sensor will send signal to auto-
dialer every time you move.
LEARN AUTO DIALER TO SEND SIGNAL TO WIRELESS SIREN (SK626) OR
AC OUTLET CONTROL (SK635) WHEN TRIGGERED.
When the auto-dialer is triggered you may want it to send a signal to either a siren or an
AC outlet control (will turn on an appliance that is plugged into it)
SK626 SIREN (Full instructions are available in the SK626 package & also at
www.idealalert.ca)
a. Open the battery cover on the back of the siren. Use a pen to press and hold down
the LEARN button for 2 seconds, you will hear a beep. Release the button. The
unit is now ready to receive the learn ID code signal from the auto dialer.
b. Trigger the auto dialer by pressing on the panic button.
c. Once learn code was successful you must ARM the siren in order to receive the
signal from the auto-dialer. There will be a 60 second delay at which time you
will hear a beep. Now it will be ready to receive signal.
SK635 AC OUTLET CONTROL
1.
Press and hold the ON/OFF/LEARN button on front of unit for 2 seconds
until you hear a beep. Now the unit is ready to learn signal.
2.
Trigger the auto dialer by pressing on the panic button.
3.
Once learn code was successful you must turn ON the AC Outlet Control
in order to receive the signal from the auto-dialer.
NOTE: You will hear a long beep to confirm that the learn code was successful. When
learn code is not successful you will hear 4 short beeps. If this happens please re-learn
again.
button seven (7) times to exit the setup mode.
Publicité
