Parkside Performance PPSTKA 12 A1 Traduction Des Instructions D'origine page 35

Cleaning
WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents
or solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.
Maintenance
The device is maintenance free.
Storage
Always store the device and accessories:
• clean
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not start
Device works with interrup-
tions
Poor sawing performance
• dry
• protected against dust
• In the case provided (22)
• out of the reach of children
The storage temperature for the re-
chargeable battery and the device is
between 0 °C and 45 °C. Avoid extreme
cold or heat during storage to ensure the
battery output is not adversely affected.
Remove the rechargeable battery from the
device before storing the device (see the
separate operating instructions for the bat-
tery and charger).
Possible cause
Rechargeable battery (24)
not inserted
On/Off switch (3) is broken Contact the service centre.
Rechargeable battery (24)
discharged
Defective motor
Internal loose contact
On/Off switch (3) is broken Contact the service centre.
Saw blade (16/17) unsuit-
able for the workpiece to be
processed
Saw blade (16/17) blunt
Low battery power
Incorrect sawing speed
GB
Fehlerbehebung
Inserting the battery (Fig. F),
p. 34
Charge the battery (see the
separate operating instruc-
tions for the rechargeable
battery and charger)
Contact the service centre.
Contact the service centre.
Use a suitable saw blade
(16/17)
Use a new saw blade (16/
17)
Charge the battery (see the
separate operating instruc-
tions for the rechargeable
battery and charger)
Adjust sawing speed
MT
35