Publicité
Les langues disponibles
Les langues disponibles
▶ Use only chargers and power tools approved for the specific battery type. Read and follow the relevant
operating instructions.
▶ Do not use or store the battery in explosive environments.
▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 13
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3
Description
3.1
Product overview
3.2
Intended use
The product described is a cordless rebar flush cutter. It is intended for flush cutting or free cutting rebars,
mild steel threaded rods, galvanized mild steel threaded rods and stainless steel threaded rods used in the
construction industry.
•
For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
•
For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
*2412811*
1
2412811
Guide
@
Spindle lock button
;
On/off switch
=
Speed adjusting knob
%
Side handle
&
Outlet
(
Chip collection bag holder
)
Hex key
+
Width adjusting block
§
Width adjusting screw
/
Chip collection bag with the adapter
:
Blade cover retaining screw
∙
Blade cover
$
Clamping screw
£
Clamping flange
|
Saw blade
¡
Positioning pins
Q
Battery release button
W
Battery status indicator
E
English
7
Publicité
