Publicité
Les langues disponibles
Les langues disponibles
Connections
Installing the Speakers on the Half Tallboy Stand
* HT-H5530HK only - Front Speakers
Turn the Stand Base upside-down and connect it to the Speaker.
1.
2.
Use the driver to combine the screws on the 3 marked holes.
Installing a speaker is finished. Follow the same steps to install
other speakers.
3.
If you want to adjust the height of the speaker, loosen a screw
on the rear of the speaker base first.
4.
Pull up the speaker in the arrow direction. (Be careful as an
excessive force may result in a physical damage.)
Fit the speaker in a height adjusting a hole, and then use a screw
5.
to fasten a speaker.
6.
This is appearance of after the speaker is installed and height
adjusted. To adjust height of other speakers, follow the step 3 ~ 5.
Installing the Speakers on the Tallboy Stand
* HT-H5530K only - Front Speakers
* HT-H5550K/HT-H5550WK only - Front/Surround
Speakers
1.
Turn the Stand Base upside-down and connect it to the
Stand.
2.
Use the driver to combine the screws on the
3 marked holes.
3.
Straighten a supplied speaker wire to the gravity direction
and put in the hole on the centre of Stand Base.
4.
Connect the upper Speaker to the assembled Stand.
5.
Insert a screw clockwise into the hole on the rear of the
speaker using a screwdriver.
And then connect a speaker cable.
6.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
1
Speaker
3
5
Stand Base
1
Stand
3
5
10
- English
Stand Base
2
4
6
or
2
4
Speaker
Stand
6
Publicité
