DeLonghi DD40P Mode D'emploi page 6

CONTROL PANEL
ON/STAND-BY
Room
temperature
Fan speed
button °F/°C
button
* (only on some models)
Description of buttons
1 ON/Standby" button
ON/Standby" button
2 "Fan" button
Press this button to select the Fan Speed (MIN or
MAX).
3 Thermometer button
Temporarily displays the temperature measured in
the room by the appliance. If you press the button
once you will see the room temperature in F for a
few seconds, then in C for a few seconds, then the
display will return to the current level of humidity
in the room. If you press the button multiple
times, it will cycle through these displays faster.
Note: Temperatures displayed are indicative only.
4 Humidity increase/decrease buttons
These buttons are used to adjust the desired
humidity level, with 5% increments; they are
also used to set the timer. From 0 -10 the hours
increase by 30 min. and from 10-24 the hours
increase by 1 hour increments.
5 Pump button
(only in some models)
When you press the "Pump button" the display
will show "PUMP". If the display shows "PUMP"
blinking, it means that the pump is not operating
correctly.
All manuals and user guides at all-guides.com
6
Decrease
Display
humidity level
button
TIMER
button
6 Timer button
If you press the TIMER button the display will
show the hours after which you want the applian-
ce to switch OFF or ON. Once the timer is set the
user can no longer adjust the %RH
Display
Meaning of the codes or symbols which may be
displayed:
-- --
Indicates that the appliance is in standby
mode.
Tank warning symbol
If the water tank is full, improperly positioned or
missing, the tank warning light will start blinking.
An alarm will sound until the tank is either emp-
tied or correctly positioned into place.
Defrosting indicator symbol
With an ambient temperature of less than 59°F
(15°C) the appliance performs defrosting cycles.
While the appliance is defrosting, the defrosting
symbol comes on and remains on until defrosting
is completed. This symbol will also be displayed if
the unit is switched on immediately after being
turned off. The unit requires 3 minutes before it
can function again.
Increase
humidity level
button
PUMP
button *