Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
Used as a USB Power Supply
Your jump starter can be used to power or recharge a wide variety of small electronic
devices.
1. Connect your device's charging cable to the device.
2. Connect the USB end of the charging cable into the USB port on the jump starter.
3. Press the Status/Power Button on the front of the unit to activate USB charging.
Note: If the unit detects a short circuit in the device connection, it will shut down USB output
to protect itself and alert the user by rapidly flashing the first two Charge Status LEDs.
Used as a Flashlight
WARNING: Avoid direct exposure of LED light to eyes. Do not shine into the eyes of
people or animals. Keep away from children.
To turn on the LED Flashlight, press the status / power button and hold for 3 seconds.
Successive pushes of the button will change the light pattern from solid to strobe to SOS
to off.
Used as a 12 Volt Jump Starter
Note: For optimum performance, do not store your Jump Starter below 50°F when using
as a jump starter. Never charge or jump start a frozen battery.
Note: When using as a jump starter, it is recommended that the unit be at or near 100%
state of charge as indicated on the unit's display.
DANGER: Never use an output cable/clamp assembly other than the one that was
included with your unit. The use of another cable/clamp assembly could result in personal
injury and/or property damage.
1. Use in a well ventilated area.
2. Shield eyes. Always wear protective eyewear when working near batteries.
3. Review this instruction manual and the instruction/safety manual provided by the
manufacturer of the vehicle being jump started.
4. Connect output cables/clamps to the jump starter through the covered jump
starting port. Be sure that the cable connection is fully engaged and secure.
5. Turn ignition off before making any vehicle connections.
6. Clamp the positive (red +) clamp to the positive terminal on the vehicle battery (for
negative ground system), or an alternate vehicle starting point as recommended
by vehicle manufacturer.
7. Clamp the negative (black, –) clamp to the a vehicle ground (unpainted portion of
the chassis or non-moving metal engine part). Never connect to the fuel line, fuel
injector or carburetor as the engine ground.
Note: Many vehicles feature alternate starting points, away from the battery.
Always use the alternate starting points whenever available.
Note: Make sure the cables are not in the path of moving engine parts
(belts, fans, etc.).
6
Publicité
