Publicité
Les langues disponibles
Les langues disponibles
Jump Starter Specifications
Battery Type:
Battery Capacity:
Operating Temperature:
Charging Temperature:
Recharge Input:
USB Output:
Jump Starting Output:
Power Indicator:
Safety Features:
Approvals:
UNIT STATUS AND RECHARGING PROCEDURES
Note: Upon initial purchase, your Jump Starter should be charged for a minimum of 6
hours. The Jump Starter should be charged every three months when not in use.
Unit Status Indication
Press the Status/Power Button on the front of the unit to power the battery status LEDs
and see the unit's state of charge. The unit's state of charge status is indicated by the
number of status LEDs lit: 1 LED - 25%; 2 LEDs – 50%; 3 LEDs – 75%; 4 LEDs – at
or near 100%.
– If the unit has below 75% state of charge, it should be charged soon.
– If the unit has below 50% state of charge, it should be charged immediately.
Note: If your unit has reached a very low State of Charge (SoC), upon power up, the
first Charge Status LED will blink rapidly (.25s on, .25s off) to alert you that immediate
charging is necessary.
It is recommended that the unit be at or near 100% state of charge when using as a
jump starter. This will greatly improve your jump starting success.
Recharging Your Jump Starter
WARNING: Never use a charger other than the one that was included with your unit.
Using an incompatible charger could damage the internal battery, which could result in
property damage or injury.
WARNING: When charging the internal battery, work in a well ventilated area and do
not restrict ventilation in any way.
Note: The unit's charge temperature range, as noted on the rear of the unit, is
32°F-108°F. If the unit is outside of this range, all Charge Status LEDs will flash
simultaneously to alert the operator that charging has not initiated. Allow the unit to
reach a temperature inside the charging temperature range to enable charging.
1. Connect the USB type C jack at the end of the included AC adapter cord to the
jump starter through the input port marked "USB-C IN."
2. Connect the USB A end of the charging cord to the included AC adapter.
Connect the male end of the AC adapter to the AC outlet.
3. Using this method, the unit will be brought to full charge automatically without
overcharging.
Lithium Ion
14.8V/37Wh
0°F – 108°F
32°F – 108°F
5V/2A
5V2.4A
14.8V/37Wh
LED Display
Built-in
ETL (Conforms to UL2743)
5
Publicité
