Publicité
Les langues disponibles
Les langues disponibles
2. Specifications
EN
Name
NAVEE Electric Scooter
Product
Model
N65i-U
[1]
Vehicle: L × W × H
47.2 × 24.0 × 49.2 in (1200 × 610 ×1250 mm)
Dimensions
After Folding: L × W × H
48.4 × 8.1 × 22.8 in (1230 × 205 × 580 mm)
Net Weight
Vehicle Net Weight
50.3 lbs (22.8 kg)
Load Range
55.1-264.6 lbs (25–120 kg)
Rider
Age (years)
16–50 years
Body Length
3.9–6.6 ft (120–200 cm)
Max. Speed
24.9 mph (40 km/h)
[2]
General Range
Approx. 40.4 miles (65 km)
Max. Climbing Angle
Approx. 24%
Assembled
Suitable Surfaces
Cement or asphalt road, with benches of less than 1 cm or crevices narrower than 3 cm
Electric
Operating Temperature
14–104 ° F (-10 to 40 °C）
Scooter
Storage Temperature
-4–113 ° F (-20 to 45 °C)
IP Rating
IPX5
Charging Time
Approx. 10 h
Model
T2213–BD5B
Nominal Voltage
46.8 V
Max. Charge Voltage
54.6 V
Rated Energy
585 Wh
Battery Pack
Intelligent Battery
Over-heating, short circuit, over-current, over-discharge, and over-charge protection
Management System
Normal Charging
32–104 ° F (0 to 40 °C）
Temperature Range
Rated Capacity
12.5 Ah
Wheel Motor Rated Power
600 W (0.6 kW)
[3]
Model
FY-5461500
Output Power
81.9 W (0.0819 kW)
Battery
Charger
Input
100–240 V~ 50/60 Hz
Rated Output
54.6 V
1.5 A
Tire
Front & Back Tires
10.5-inch Tubeless Tires
Frequency Band
2.4000 – 2.4835 GHz
Bluetooth
Max. RF Power
8 dBm
[1] Vehicle height: From the ground to the top of the scooter.
[2] General range: Measured when there is no wind and at 77 ° F (25 ° C), the scooter is fully charged to ride at a constant speed of
9.3 mph (15 km/h) on a flat surface with a load of 165.3 lbs (75 kg).
[3] To recharge the battery, only use the battery charger provided in the package. Please see battery charger parameters in Specifications.
05
3. Certification
FCC Supplier's Declaration of Conformity
This supplier's declaration of conformity is hereby for
Product: NAVEE Electric Scooter
Model Number(s): N65i-U
Brand/Trade: NAVEE
We declare that the above mentioned device has been tested and found in compliance with CFR 47 Part Regulation.
Responsible Party—U.S.Contact Information
Company: Brightway Innovation Intelligent Technology (Suzhou) Co., Ltd.
Address: Building A2, Shangjinwan Headquarters Economic Park, No.2288, Wuzhong Avenue, Wuzhong Economic
Development Zone, Suzhou Jiangsu P.R. China
Country: China
FCC Compliance Statement for USA
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Note
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
EN
06
Publicité
