Sauber VCE-108276.9 Mode D'emploi page 15

c. Air outlet filter
1. Take out the air outlet filter for cleaning and change.
Please note:
The sponge filter material in the cleaner will became dusty over time. This is normal and will not affect the
performance of the filter. If the sponge filter is so dusty that suction does not return to 100%, we suggest that
the filter be removed then rinsed under the faucet and allowed to dry for 24 hours by airing not near the fire or
some high temperature objects before refitting into the vacuum. This should be done once six months or when
suction appears to be reduced obviously.
NOTE:
The motor protection filter is under the dust tank; it should be removed and rinsed twice a year or whenever it
is visibly clogged. If the filter is damaged, a new filter should be replaced.
Important:
Please note that there is a safety switch inside the vacuum to prevent the unit from being run with high vacuum
rate. If the vacuum is too high, the safety switch will be turned on. In this case, it can minish the vacuum rate
and protect the motor from being broken.
Note:
The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will overheat and
could become damaged.
If the suction power of the vacuum cleaner gets low please check the hose for obstacles. You can open the hose
by pressing the square part on the hose handle. Take apart the two parts and remove any obstacles. To assemble
the hose again first press the flexible hose into the handle and then click in the connection part.
- 14 -