2measure 260302 Notice D'utilisation page 6

Starting:
Place 3 x LR03 AAA batteries (not included) in the battery chamber of the weather station or connect the power
supply unit. The station will start operating automatically. Next, in the external sensor chamber, set the slider
to channel 1 and then insert 2 x LR03 AAA batteries (not included).
If the connection with the external sensor is established, the display will show the temperature and humidity
measurements obtained by the sensor. In order to manually run an attempt to connect the station
to the external sensor, push and hold the "CH" button. The channel indicator on the display will start flashing.
In order to connect additional sensors (purchased separately), it is necessary to set the slider in the additional
sensor chamber to channel 2 or 3 and then insert 2 x LR03 AAA batteries (not included) there. The sensor
should connect automatically to the station. In order to manually run an attempt to connect the station
to the external sensor, push and hold the "CH" button. The channel indicator on the display will start flashing.
In order to switch the sensor being the source of values displayed, press the "CH" button the back of the device.
In order to manually start/stop synchronisation with the radio transmitter, press and hold the "DOWN" button.
During synchronisation the possibility of configuring other functions is blocked. Once the connection with
the radio transmitter is established, the display shows an indicator thereof and the lock will be set automatically.
Note! It may be necessary to specify manually the appropriate time zone where the user is located
(see "Display settings").
Possible sources of interference for signal reception:

household appliances without radio interference suppressors,

TV sets within distance of less than 2 metres,

high-frequency emission devices,

topographical location (too large distance from the transmitter, hilly terrain, etc.),

meteorological disorders.
Display settings:
In order to configure the clock/calendar manually, press and hold the "MODE" button. After a moment
the display will show a flashing year number. Use the "UP" and "DOWN" buttons to set the appropriate value.
Next, confirm the selection by pushing the "MODE" button once and move to next function settings.
If the "MODE" button is not pushed for the next several seconds, the station will return to the normal display
mode.
Function setting order:
1. Year
2. Month
3. Day
4. Weekday display language
4. Hour
6. Minutes
7. Time zone
Alarm clock settings:
In order to configure the alarm clock, press and hold the "ALARM" button. The display will show the alarm clock
settings mode and the hour digit(s) will start flashing. Use the "UP" and "DOWN" buttons to set the appropriate
value. Confirm the selection by pushing the "ALARM" button once and move to setting minutes. The minute
digits will start flashing. After selecting and approving the settings, the station will return to the normal display
mode.
In order to activate/deactivate the alarm clock function, push the "ALARM" button once.
The current functions status is shown in the form of icon appearing on the display.
Snooze function:
After the alarm is activated, push the "SNZ" button. This will silence the alarm and set its repeated activation
to 5 minutes later. The current functions status is shown in the form of icon appearing on the display.
6