Publicité
Les langues disponibles
Les langues disponibles
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
„ Driving fasteners into wood
„ Driving fasteners to secure fencing wire and wire screen
NOTE: Only use with low voltage wire.
WARNING:
Do not use this tool for fastening high voltage electrical
cables or wire. Stapling low-voltage, current protected
wiring is allowed. During installation do not have power
running to the wire being fastened. After installation of
the wire, verify that the wire was not damaged during
installation. This can cause a short circuit leading to
electrical shock or a fire hazard.
LED LIGHT FUNCTIONS
See Figure 1, page 9.
When a charged battery pack is installed in the tool, the
LED light will indicate the status of the tool when the tool
is powered on.
OPERATION
TOOL STATUS
Normal
Low Battery
Exhausted Battery
Over Temperature
Lockout/Requires Service
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 9.
To install:
„ Unscrew and remove the battery cap.
„ Insert the battery pack into the product as shown.
„ Place the cap over the battery pack and push down until
the cap meets the threads at the end of the tool.
„ Screw the cap on securely.
NOTE: Do not attempt to use this product if the battery
cap is not securely closed.
To remove:
„ Unscrew and remove the battery cap.
„ Remove the battery pack from the tool.
For complete charging instructions, see the operator's manual
for your battery pack.
LOADING STAPLES
See Figure 2, page 9.
„ Remove the battery pack.
„ Hold the tool upside down. Squeeze the magazine latch
and slide the magazine open.
„ Insert staples into the middle channel against the right
side of the magazine with the crown side down and the
legs facing upward.
„ To close the magazine, push it into the tool until it clicks.
„ An indicator window on the side of the tool lets the oper-
ator know when the tool is running low on staples.
LOADING NAILS
See Figure 3, page 10.
„ Remove the battery pack.
„ Hold the tool upside down. Squeeze the magazine latch
and slide the magazine open.
„ Insert nails into the middle channel against the left side
of the magazine with the nail head side down and the nail
point facing upward.
„ To close the magazine, push it into the tool until it clicks.
„ An indicator window on the side of the tool lets the oper-
ator know when the tool is running low on nails.
6 — English
LED LIGHT SCENARIO
Solid Green (No Flashes)
Flashing Red (3 Flashes)
Flashing Red (6 Flashes)
Flashing Red (9 Flashes)
Flashing Orange (Indefinite)
Publicité
