Cutter Blade Assembly And Disassembly And; Adjustment Of Cutter Blade Height - Hitachi P 20SF Mode D'emploi Et Instructions De Securite

English
CUTTER BLADE ASSEMBLY AND
DISASSEMBLY AND ADJUSTMENT OF
CUTTER BLADE HEIGHT
WARNING:
● Be sure to switch power OFF and disconnect the
plug from the receptacle to avoid serious trouble.
● Be careful not to injure your hands.
1. Cutter blade disassembly
(1) As shown in Fig. 8 use the accessory box wrench to
withdraw the three bolts used to retain the cutter
blade, and remove the cutter blade holder.
Box wrench
Blade holder
(2) As shown in Fig. 9, slide the blade in the direction
indicated by the arrow to disassemble the blade.
2. Cutter blade assembly
CAUTION
Prior to assembly, thoroughly wipe off all swarf
accumulated on the cutter blade.
(1) Insert a turned portion of set plate (A) attached to
the blade into a groove on the flat portion of the
cutter block. (Fig. 10, 11)
Set the blade so that both sides of the blade
protrude from the width of the cutter block by about
3/64" (1 mm) (Fig. 12)
10
01Eng_p20SF_US
Fig. 8
Set plate (B)
Fig. 9
10
Flat portion of the
cutter block
Set plate (A)
Groove
Fig. 11 (Correct installation)
3/64" (1 mm)
Blade
(2) Place the blade holder on the completed assembly,
as shown in Fig. 13, and fasten it with the three bolts.
Ensure that the bolts are securely tightened.
Bolt
3/22/12, 9:49
Set plate (A)
Fig. 10
Blade
3/64" (1 mm)
Cutter block
Fig. 12
Blade holder
Fig. 13