Publicité
Les langues disponibles
Les langues disponibles
Ensure that it is positioned correctly. The nose
must correspond with the groove (see Fig. G).
Screw the light bulb
the LED light (see Fig. H).
Attach the lampshade
thumb screws
for this purpose (see Fig. I).
5
CAUTION! Do not use pliers to tighten the
thumb screws
. This could cause the glass
5
of the lampshade
10
to injuries caused by splinters of glass.
Replace the fuse or switch on the circuit breaker
(I setting) in the fuse box.
Your product is now ready to use.
Initial use
Switching the LED light on
and off (see Fig. J)
Pull on the pull switch
light on.
Pull on the pull switch
LED light off.
Switching the ceiling fan on
(see Fig. J)
Pull on the pull switch
fan on. The ceiling fan will run at high speed.
Pull on the pull switch
will run at medium speed.
Pull on the pull switch
will run at low speed.
Pull on the pull switch
ceiling fan off.
Setting the right / left rotation
(see Fig. J)
CAUTION! RISK OF INJURY! Always switch
the ceiling fan off and wait until it is still before
using the rotation direction switch
the rotation direction switch while the ceiling
20 GB/IE
into the socket
of
9
7
. Use the pre-installed
10
to crack. This could lead
to switch the LED
8
again to switch the
8
to switch the ceiling
6
again. The ceiling fan
6
again. The ceiling fan
6
again to switch the
6
. Operating
4
fan is on can lead to injuries and / or material
damage.
In low temperatures, slide the rotation direction
switch
upwards. The ceiling fan will distribute
4
the warmth in the room.
In high temperatures, slide the rotation direction
switch
downwards. The ceiling fan will create
4
a cooling flow of air.
Inserting / replacing the light bulb
DANGER OF ELECTRIC
SHOCK! Before changing the light bulb, make
sure that the power supply to which the product
is connected is not live. To do this, remove the
fuse or switch off the circuit breaker (0 setting)
in the fuse box.
CAUTION! RISK OF BURNS DUE TO HOT
SURFACES! Allow the LED light to cool down
completely.
Loosen the lampshade
remove them carefully.
Carefully turn the defective light bulb
wise out of the socket
Use a clean, lint-free cloth to replace the bulb.
Screw the new light bulb
socket
.
7
Please refer to the chapter "Technical data" to
find out which light bulb is required.
Attach the lampshade
for this purpose (see Fig. I).
5
Replace the fuse or switch on the circuit breaker
(I setting) in the fuse box.
Maintenance and cleaning
WARNING! DANGER OF ELECTRIC
SHOCK! Always disconnect the product
from the mains before cleaning. To do
this, remove the fuse or switch off the circuit breaker
(0 setting) in the fuse box.
WARNING! DANGER OF ELECTRIC
SHOCK! To ensure electrical safety,
never clean the product with aggressive
detergents or immerse it in water.
thumb screws
and
10
5
anticlock-
9
.
7
clockwise into the
9
. Use the thumb screws
10
Publicité
