Publicité
Les langues disponibles
Les langues disponibles
- Screwdriver
- Power drill
- Drill bit
- Side cutters
- Ladder
- Open-end spanner
Prior to installation
Prior to installation, familiarise yourself with all
the instructions and diagrams in this manual as
well as with the ceiling fan itself.
Before installation, ensure that the circuit to which
the product will be connected is not live. To do
this, remove the fuse or switch off the circuit
breaker (0 setting) in the fuse box.
Prior to installation, make sure that the installation
site is suitable to bear the weight of the product.
Use a voltage tester to verify that cables are
not live.
Assembly
Note: You will need a power drill for the installa-
tion work.
Note: Please also follow the instructions for your
power drill.
Make sure that you do not drill
into any electrical wiring, gas or water pipes inside
the wall.
Installing the product
Note: Remove all packaging materials from the
ceiling fan.
Fasten the fan blades
ers
using the nuts
20
washers and screws
Remove the pre-installed screws
rotor housing
.
3
Attach the fan blade holders
housing
. To do this, use spring lock washers
3
and the screws
pre-installed on the rotor hous-
3 a
ing
. Make sure that all the fan blades
3
to the fan blade hold-
21
, spring lock washers,
13
(see Fig. A).
12
on the
3 a
to the rotor
20
21
have either the side with the wood effect or the
white site facing downwards (see Fig. B).
Before continuing with the installation, remove the
fuse or switch off the circuit breaker (0 setting)
in the fuse box.
Unscrew the right-hand fixing screw
ding the washer and tooth lock washer, which is
located at the side of the mounting bracket
Unscrew the left-hand fixing screw
the washer and the tooth lock washer. Mark the
drill holes using the holes in the mounting bracket
intended for the screws
19
Now drill the fixing holes. Make sure that you
do not damage the power cord (external)
water pipes or electrical cables.
Insert the wall plugs
14
(see Fig. C). If necessary, use a hammer to
help you.
IMPORTANT! The chosen installation location
must be able to hold the total weight of the cei-
ling fan.
Guide the power cord (external)
intended central hole in the mounting bracket
Attach the mounting bracket
spring lock washers and screws
(see Fig. C).
Using one of the holes intended for this purpose,
hang the cover
on the hook
2
ting bracket
(see Fig. D).
19
Connect the power cord (external)
lustre terminal
in the mounting bracket
17
Please also make sure that the colours of the
connected wires match (black or brown live
wire = L symbol, blue neutral wire = N symbol,
protected ground wire
Fig. D)).
Insert the connection cable
bracket
into the connection cable port
19
on the ceiling fan (see Fig. E).
Remove the cover
from the hook
2
Now place the cover
2
bracket
by guiding the fixing screws
19
into the grooves on the cover and then turning
the cover
anticlockwise (see Fig. F).
2
Now screw the product and the mounting bracket
together using the four fixing screws
19
the spring lock washers and tooth lock washers.
, inclu-
15
.
19
including
15
as a guide.
11
,
22
into the drilled holes
through the
22
.
19
using the washers,
19
provided
11
on the moun-
18
with the
22
.
19
= green-yellow (see
of the mounting
16
1
.
18
on the mounting
15
and
15
GB/IE
19
Publicité
