Salicru EQUINOX SLC EM Lite Mode D'emploi page 93

Comunication
2.
to find the devices and also allows to visualise the number of
connected and communicating Solar Inverters.
Export Power Control: This window allows you to configure
3.
multiple parameters of the Export Power Control system.
Auto Mode: Enabling this work mode allows the Active
a.
Power Imported/Exported from the Grid to be controlled
by adjusting the parameter with tenths of a percentage
(-1000 to 1000), where -1000 is equivalent to -100.0% of
Energy Imported from the Grid and 1000 is equivalent to
100.0% of Energy Exported to the Grid. In the case of a
three-phase system, it allows different phases to be moni-
tored:
To access the calibration parameters of the current
transformers, a password is required: 'pass-
word123'.
USER MANUAL
bus: Allows to scan the communication bus
MIN: Monitoring of the Low Consumption Phase.
–
AVG: Monitoring of the Average Consumption of all
–
Phases.
MAX: Follow-up of the Phase with the Highest Con-
–
sumption.
The following configuration allows compli-
ance with RD 244/2019 Annex I ITC-BT-40 and
UNE 217001:2020 Tests for systems that prevent the
discharge of energy into the distribution network:
Imported/Exported Active Power
-100.
Control Phase:
MIN.
Up to a maximum of 30 teams working in parallel.
Percentage of export
b.
ting the export power percentage for all EQX2 Solar In-
verter models (the Solar Inverter is responsible for limiting
the generation).
Safety Parameters: Allows you to configure the security pa-
4.
rameters of the equipment.
Percentage:
power: If enabled, it allows set-
SLC ENERGY MANAGER ENERGY METER
93