Publicité
Les langues disponibles
Les langues disponibles
PLACEMENT AND INSTALLATION
CAUTION:
After unpacking, you MUST allow this appliance to stand upright for at least 2
hours to allow the lubricant and refrigerant to drain back into the compressor
and stabilize. Failure to do so may adversely affect performance and the
lifetime of this unit.
Location
Place your appliance in a location that is strong enough to support its total weight,
keeping in mind that it will weigh substantially more when fully loaded. In order to
prevent vibration and noise, the keg beer dispenser should be leveled by adjusting
the front leveling legs.
Locate the appliance in a dry area out of direct sunlight and away from heat sources
such as an oven or boiler.
Choose a location that has ambient temperatures above 50°F and below 90°F.
Operation outside this temperature range may result in lowered efficiency or cause
other adverse effects.
Do not kink or pinch the power supply cord between the appliance and the wall or
cabinet.
Warning: This appliance must be installed with a grounded circuit.
Accessories
Remove all packing materials and parts. Inspect to make sure all parts listed below
are present and in good condition. In the event that any accessories are missing and
/or damaged, please either call us at 800-932-4267 or 718-893-3900 or fill out a
service request on our website, www.summitappliance.com/support.
1 Draft arm assembly (with washer)
1 CO
cylinder
2
1 CO
regulator
2
1 Keg tap (American Sankey type)
1 Cleaning kit
Vinyl tubing
1 Stainless steel (removable) floor to protect the unit during keg insertion
1 Guard rail
1 Drip tray
4 Casters (for conversion to portable beer cooler)
2 Hose clamps
8 Small Phillips-head screws
4 Large Phillips-head screws
2 Retainer fixing screws
5
Publicité
