GYS NOMAD POWER 15 AIR Mode D'emploi page 12

PROTECTIONS
This device is protected against short-circuits, overloads, deeply discharge and polarity inversions.
ANOMALIES, CAUSES, REMÈDES
TROUBLESHOOTING
No response while pressing the ON/
1
OFF button
«Error» light ON on the jumper
2
cable.
«Error» light flashes red + alarm
3
beep.
The device is warm whilst connected
4
to a laptop.
12
NOMAD POWER 15 AIR
CAUSES
The NOMAD POWER is discharged.
Internal battery voltage < 11.0V.
Polarity reversal
Short-circuit
Clamps have been left connected to the battery.
-
REMEDIES
Charge the product (see page 9).
Charge the product.
Check that the clamps are well connected and unplug/plug back the jumper
cable.
Check that the clamps are well connected and unplug/plug back the jumper
cable.
Remove the 2 clamps from the car battery in order to protect the device.
Remove laptop's battery or unplug the NOMAD POWER from the laptop for 5
minutes and plug it back again.
EN