GYS NOMAD POWER 15 AIR Mode D'emploi page 11

POWER SUPPLY
not supplied
AIR COMPRESSOR
Suitable for vehicles with 12V batteries, this air compressor is ideal for inflating city car tires, motorcycles, bicycles and
inflatable boats, balloons, etc..
Terms of use :
1. Voltage input / current : DC12V / 10A
2. Do not use the air compressor on truck tires and other large tires.
3. Although the air compressor is capable of inflating car tires, it is advisable to let it cool down for a few seconds
every ten minutes.
FLASHLIGHT FUNCTION
NOMAD POWER 15 AIR
1 - Plug the auxiliary cable to PC port 19V 3.5A
2 - Select the appropriate connection for your laptop and connect it on the
auxiliary cable.
3 - Plug the auxiliary cable with the right connection on the power supply
socket of your laptop.
4 - Press the ON button to start the charge.
1 - Plug the auxiliary cable (not supplied) to the 12V 12A NOMAD POWER
port.
2 - Plug the auxiliary cable (not supplied) to your 12V device.
3 - Press the power button.
1. Connect the air outlet (1) (tip (2) if necessary) on the tire valve, and close the
clamping lever to prevent the air from escaping out of the tire.
2. Plug the air compressor's cable (3) on the vehicle's 12V cigarette lighter socket.
3. Press the air compressor's «ON» button to start inflating.
4. During the inflating operation, the dial's needle goes up as a function of the
pressure. When the needle reaches the pressure recommended by the manufac-
turer of your vehicle, turn off the air compressor, open the clamping lever and
remove the air hose from the tire valve.
Features
Voltage
Power
Pressure
Air output
Press the power button for 3 seconds to activate the LED.
Briefly press the button to switch lighting modes (4 available modes: normal,
flash, SOS and OFF).
DC 12V
6A 60W
85PSI 6 BAR
10 L/min
EN
of the NOMAD POWER.
11