ABB PASSERELLE Nexus Pro Mode D'emploi page 8

FCC Statement
This device complies with part 15 of the FCC rules.
FCC ID: QOQBGM13P
The antennas must be installed such that a minimum separation distance of 2 inches(50.5mm) is maintained
CAUTION:
between the antennas and all persons at all times.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT:
Innovation, Science and Economic Development Canada (ISED)
The term "ISED": before the certification/registration number only signifies that the Innovation, Science and Economic Development
Canada technical specifications were met.
IC: 5123A-BGM13P
Non-Intentional Radiator: CAN ICES-005 (B) / NMB-005 (B)
Canadian Wireless Regulatory
This Class B digital apparatus meets all the requirements of the Canadian Interference Causing Equipment Regulations. This device
contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's license-
exempt RRS(s). Operation is subject to the following two conditions: a) this device may not cause any interference, and b) this device
must accept any interference, including interference that may cause undesired operation of the device. To prevent radio interference to
the licensed service, this device is intended to be operated indoors, and away from windows to prevent maximum shielding. Equipment
(or its transmit antenna) that is installed outdoors is subject to licensing.
Unauthorized Antenna Modifications
Use only the supplied integral antenna. Unauthorized antenna modifications or attachments could damage the
unit and may violate FCC regulations. Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Precautions against electrostatic discharge (ESD)
Make sure to discharge any built-up static electricity from yourself and your electronic measurement devices before
touching this equipment. The recommendation from the dealer is that you take this precaution before installation and
connecting this equipment.
®
The Bluetooth word mark and logo are registered trademarks owned by Bluetooth
under license. Other trademarks and trade names are those of their respective owners.
This product comes with a 5 year limited warranty.
For full warranty information, refer to brand on web-page (http://www.tnb.ca.abb.com).
Contact information:
Nexus® Technical Support: ca-eml-nexus-techsupport@abb.com
Tel: (888) 552-6467
© 2024 ABB. All rights reserved.
Changes or modifications not covered in this addendum must be approved in writing by the manufacturer.
Changes or modifications made without written approval may void the user's authority to operate this
equipment.
Fax: (800) 316-4515
Nexus®Pro GATEWAY
®
SIG. Inc. and any use of such marks by ABB Inc. is
03/24 750.2095 Rev. B
4/4