ABB PASSERELLE Nexus Pro Mode D'emploi page 7

Installing the Gateway to a DIN Rail
1. Ensure power is off.
2. Hook lower latch of DIN rail adapter mounting clip to lower edge of the DIN rail as shown in figure 4.
3. Lift Gateway up onto DIN rail and snap into top of the DIN rail adapter mounting clip as shown in figure 4. The upper latch of the DIN
rail adapter mounting clip will lock onto the DIN rail when released.
Figure 4: Gateway installation
Removing the Gateway from a DIN Rail
1. Ensure power is off.
2. Pull up on the Gateway to release the upper latch of the DIN rail adapter mounting clip.
3. Tilt the upper part out to un-latch and lower the Gateway off the DIN rail.
Figure 5: Gateway removal
Supplying Power and Turning ON the Product
1. Using the supplied power adapter, plug the connector into the "Power in" connector on the bottom of the Gateway.
2. Plug the adapter into a standard wall receptacle.
ETH1
1 Ref.#
1
2
Figure 6: Supplying power
L' li t ti él t i
Cleaning the Product
1. Use water-based, non-flammable, cleaning products to remove dirt.
2. Use a dry, lint-free, cloth to remove dust.
3. Never use detergents, aerosol sprays, solvents or abrasive sponges.
Tel: (888) 552-6467
© 2024 ABB. All rights reserved.
(Antennas not shown for clarity)
Gateway
DIN rail
(Antennas not shown for clarity)
POWER IN
12-24 VDC
NOMINAL
Description
Ethernet ETH 1 connector
Power IN connector
Fax: (800) 316-4515
Gateway
DIN rail
DIN rail adapter
mounting clip
DIN rail adapter
mounting clip
2
Nexus®Pro GATEWAY
POWER IN
12-24 VDC
NOMINAL
03/24 750.2095 Rev. B
3/4