Publicité
Les langues disponibles
Les langues disponibles
c) Establishing voltage supply
1. Make sure that the load to be connected to the power supply unit is turned off.
2. Then connect the low voltage connector to the power supply socket of your load.
3. Plug the standardised European plug to a standard mains socket.
Never use the power supply unit when it has been opened, shows a damaged
power cord/connection or a damaged (cracked/broken) housing. Possible
danger to life!
Before operation, check whether the AC line voltage is within the allowable
range.
9. Care and cleaning
Do not use any aggressive cleaning agents, rubbing alcohol or other chemical
solutions as they can cause damage to the housing and malfunctioning.
•
This product requires no maintenance. Never attempt to disassemble it. This product must
only be repaired by an expert or a service shop, as otherwise it might be damaged.
•
Disconnect the product from the mains before each cleaning.
•
Clean the product with a dry, fibre-free cloth.
10. Troubleshooting
Problem
No power to
connected device
Possible solution
No supply voltage, check the following:
•
The fuse of the mains socket.
•
If the mains plug is correctly connected.
•
If the correct voltage been set.
•
The correct polarity been selected.
•
If the power supply unit overloaded.
•
If the voltage selection switch has properly clicked into place.
17
Publicité
